Extension Forced Idle; Module Idle - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
1 Programming Basics
Idle States
paragraph). The following procedures can be performed only when the line or
trunk being programmed is idle:
Identify loudspeaker paging extension jack
Assign trunks to pools
Specify incoming or outgoing DID or tie-trunk type
Specify tie-trunk direction
Specify tie-trunk E&M signal

Extension Forced Idle

When an extension is forced idle, no calls can be made or received on that
telephone or data equipment. The following procedures can be performed only
when the extension being programmed is idle:
Assign calling restrictions
Assign pool dial-out restrictions
Copy extension assignments
Assign lines, trunks, or pools to extensions
Assign labels to a personal directory
Use centralized telephone programming
When the telephone is forced idle, the following occurs: Multiline telephone users
hear a signal, indicating that the telephone cannot be used; display telephone
users see the message Wait: System Busy; single-line telephone users do not
hear a dial tone.
100D Module Idle
The following procedures can be performed only when the 100D module is idle:
Specify board type
Specify frame format
Specify board signaling format
Specify board suppression format
Specify board facility compensation
1
1
Issue 1
April 1999
1-56