Table 27: Management Port Connector Pinout Information for J-EX8200 Switches (continued)
Pin
3
4
5
6
7
8
Related
Documentation
Optical Interface Support in J-EX8200 Switches
Signal
TRP2+
TRP3+
TRP3-
TRP2-
TRP4+
TRP4-
See Routing Engine (RE) Module in a J-EX8216 Switch on page 26 for port location.
Connecting a J-EX Series Switch to a Network for Out-of-Band Management on page 135
SFP+ ports in 8-port SFP+ line cards used in J-EX8200 switches support SFP+
transceivers. SFP ports in 48-port SFP line cards used in J-EX8200 switches support SFP
transceivers. This topic describes the optical interfaces supported for transceivers used
in the SFP and SFP+ line cards for J-EX8200 switches. It also lists the copper interface
supported for the SFP transceivers.
NOTE: Use only optical transceivers and optical connectors purchased from
Dell for your J-EX Series switch.
The Gigabit Ethernet SFP and SFP+ transceivers installed in J-EX8200 switches support
digital optical monitoring (DOM): you can view the diagnostic details for these transceivers
by issuing the operational mode CLI command
does not give any output for copper transceivers, Fast Ethernet transceivers, or transceivers
not purchased from Dell.
The two tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimode fiber-optic (MMF) cables for SFP and SFP+ transceivers
and over the copper interface for SFP transceivers:
Table 28 on page 52—Optical interface support for SFP+ transceivers in 8-port SFP+
line cards
Table 29 on page 55—Optical interface support and copper interface support for SFP
transceivers in 48-port SFP line cards
Chapter 3: Component Specifications
Description
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
show interfaces diagnostics
. The command
51