Optical Interface Support In J-Ex8200 Switches - Dell PowerConnect J-EX8208 Hardware Manual

Table 24: Management Port Connector Pinout Information for J-EX8200 Switches
Pin
1
2
3
4
5
6
7
8
Related
Documentation

Optical Interface Support in J-EX8200 Switches

Signal
TRP1+
TRP1-
TRP2+
TRP3+
TRP3-
TRP2-
TRP4+
TRP4-
See Switch Fabric and Routing Engine (SRE) Module in a J-EX8208 Switch on page 22
for port location.
Connecting a J-EX Series Switch to a Network for Out-of-Band Management on page 140
SFP+ ports in 8-port SFP+ line cards used in J-EX8200 switches support SFP+
transceivers. SFP ports in 48-port SFP line cards used in J-EX8200 switches support SFP
transceivers. This topic describes the optical interfaces supported for transceivers used
in the SFP and SFP+ line cards for J-EX8200 switches. It also lists the copper interface
supported for the SFP transceivers.
NOTE: Use only optical transceivers and optical connectors purchased from
Dell for your J-EX Series switch.
The Gigabit Ethernet SFP and SFP+ transceivers installed in J-EX8200 switches support
digital optical monitoring (DOM): you can view the diagnostic details for these transceivers
by issuing the operational mode CLI command
does not give any output for copper transceivers, Fast Ethernet transceivers, or transceivers
not purchased from Dell.
The two tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimode fiber-optic (MMF) cables for SFP and SFP+ transceivers
and over the copper interface for SFP transceivers:
Table 25 on page 46—Optical interface support for SFP+ transceivers in 8-port SFP+
line cards
Chapter 3: Component Specifications
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
show interfaces diagnostics
. The command
45