Management Port Connector Pinout Information For A J-Ex8200 Switch - Dell PowerConnect J-EX8216 Hardware Manual

Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
Table 26: J-EX Series Switches Console Port Connector Pinout Information
Pin
1
2
3
4
5
6
7
8
Related
Documentation

Management Port Connector Pinout Information for a J-EX8200 Switch

Table 27: Management Port Connector Pinout Information for J-EX8200 Switches
Pin
1
2
50
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a J-EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Signal
RTS Output
DTR Output
TxD Output
Signal Ground
Signal Ground
RxD Input
CD Input
CTS Input
See Routing Engine (RE) Module in a J-EX8216 Switch on page 26 for port location.
Connecting a J-EX Series Switch to a Management Console on page 136
The management port on a J-EX8200 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection. Two LEDs on the port indicate link/activity on the port and the administrative
status of the port. See "Management Port LEDs in J-EX8200 Switches" on page 29.
Table 27 on page 50 provides the pinout information of the RJ-45 connector. An RJ-45
cable, with a connector attached, is supplied with the switch.
Signal
TRP1+
TRP1-
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
Description
Transmit/receive data pair 1
Transmit/receive data pair 1