Section 2- Getting Started; Rear Panel Connections - dbx DriveRack PA User Manual

DriveRack PA+
Section 2
®
Getting Started

Section 2- Getting Started

2.1 Rear Panel Connections

IEC Power Cord Receptacle
The DriveRack PA+ comes with a power supply that will accept voltages ranging from
100V-120V at frequencies from 50Hz-60Hz. An IEC cord is included. EU version accepts
220V-240V at frequencies from 50Hz-60Hz.
USB Connection
The USB connector allows users to connect the DriveRack PA+ to their computer to perform
firmware updates using HiQnet System Architect Software via System Architects Firmware
Updater. You may download HiQnet System Architect at the HiQnet Web site:
http://hiqnet.harmanpro.com/downloads.php
Outputs 1-6
The output section of the DriveRack PA+ offers six electronically balanced XLR connectors.
Inputs 1-2
The input section of the DriveRack PA+ offers two electronically balanced XLR connectors.
+4/-10dBv Switch
This switch changes the level from either +4 or -10dBv.
Ground Lift Switch
The ground lift switch lifts the pin 1 chassis ground of both input XLR connectors.
4