Loose Fuel Filler Cap Message; Emissions Inspection And Maintenance Programs - Chrysler Sebring Convertible Owner's Manual

Loose Fuel Filler Cap Message

After fuel is added, the vehicle diagnostic system can
determine if the fuel filler cap is possibly loose or
improperly installed. A "GASCAP" message will be
displayed in the instrument cluster. Tighten the gas cap
until a clicking sound is heard. This is an indication that
the gas cap is properly tightened. Press the trip odometer
"Reset" button to turn off the message. If the problem
persists, the message will appear the next time the
vehicle is started. This might indicate a damaged cap. If
the problem is detected twice in a row, the system will
turn on the "Malfunction Indicator Light (MIL)." Resolv-
ing the problem will turn the MIL light off.
MAINTAINING YOUR VEHICLE 373
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle's emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the Malfunction
Indicator Light (MIL) is functioning and is not on
when the engine is running, and that the OBD II system
is ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may not be ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
7