Kit Installation (Detailed); Making A Backup Of The Pmp To Be Replaced; Replacing The Faulty Pmp; Removing The Input Module - Barco Galaxy NH-12 Option Installation Manual

3. KIT INSTALLATION (DETAILED)

C
AUTION
3.1

Making a backup of the PMP to be replaced

Introduction
If a PMP fails, communication via Ethernet is most probably still possible. This implies that a backup can still be made using the
Projector Support tool. If there is no more communication with the faulty PMP, Barco's helpdesk must be contacted.
How to make a backup of the PMP to be replaced?
See "Backup and restore data", page 15.
3.2

Replacing the faulty PMP

3.2.1

Removing the input module

Input layers 3, 4 and 5 can be installed or removed without taking out the complete input module!
The input module with all of the input layers can be removed as a unit!
Necessary tools
Torx screwdriver T10
How to remove the input module?
1. Remove the covers (see concerning chapters):
- rear cover
- top cover
- engine fan cover 1
2. Remove the four screws fixing the preformatter unit to the input module
Image 3-1
Preformatter unit: fixing screws
R59770498 PMP KIT 28/02/2011
:
This procedure may only be performed by Barco trained and qualified technicians.
3. Kit installation (detailed)
7