For Models With Slideout - Jayco JAY SERIES Owner's Manual

Place the bent hook into the bracket attached to the front wall. (Fig. 10)
7. Pull the beds out until the rail hits the bed stop. Distribute the awning panel over the
bunk and place the corners of the tent over the bed corner. Again, be sure the beds are
extended all the way out against the stops.
WARNING: Do not use bed braces if they are bent or damaged.
Replace all damaged braces.
8. Place the flattened end of the straight bed brace into the slot provided on the frame of
the camper. Place the angled and smashed end of the straight bed brace into the bed
bracket near the outer corner under the plywood bunk bed. (Fig. 10)
9. Now, complete raising the roof until the gray limit cable is almost tight and the tent is
almost taut. DO NOT OVERTIGHTEN. (Fig. 11)
Caution: If the limit cable is raised too high, lifter system/tent
damage could occur and the door will not fit properly.

For Models With Slideout

a. Pull out the slideout using the handle(s) located on the side
of the slideout.
Caution: Do not extend the slideout before pulling the beds out.
b. Pull the tent flaps located on the side of the slideout out
over edge and attach them to the Velcro.
10. Enter the unit and set up the kitchen flip-top. Attach the stove grate.
Jay Series/Baja/Select Folding Camping Trailer
Fig. 10
Setting Up Camp...
Fig. 11
45