Using Display Screen Temperature Markers - Fluke TiR4 User Manual

Using Display Screen Temperature Markers

You can annotate images with various types of markers to help you interpret or
analyze images. For example, you can highlight particular areas of interest in
an image or highlight critical objects whose minimum, maximum, or average
temperatures must be in a particular range.
Use the following basic marker options:
Four standard spot temperatures: hot, cold, and center points each marked
with a crosshair and the mouse pointer location, marked by the tip of the
pointer.
Maximum, minimum, and average temperatures for the center box.
You can enable these markers to appear on the display screen in scan target
mode and/or on a saved image you open. With the mouse pointer marker
enabled, you can move the pointer around the display screen to reveal the spot
temperatures at any place on the image.
To add advanced markers, see Chapter 7, User-Defined Temperature
Markers.
Movable points and boxes and automatic hot and cold point detection
functions are available on TiR2, TiR4, Ti45 and Ti55 models only.
The pointer may change orientation as it approaches the edge of the
display screen.
"Unchecking" the mouse temperature removes the pointer
temperature digits only; the pointer itself still appears on the display
screen.
To enable/disable spot temperature marker functions from either scan target
mode or from an open image:
1. Tap F.
2. Use the mouse controller to position the pointer over Image Settings on
the popup menu and tap E.
3. Position the pointer over the Display tab and tap E.
Analyzing and Enhancing Images
Using Display Screen Temperature Markers
Note
4
4-7