Euro-Pro 9105 Instruction Manual page 9

CONNECTING THE MACHINE TO THE POWER SOURCE
Foot control
Attention: Consult a qualified electrician if in doubt as how to connect the machine to the
power source. Unplug the power cord when the machine is not in use.
The appliance must be used with the foot controller 4C-337G manufactured by
MATSUSHITA ELECTRIC (TAIWAN) CO., LTD.
Message and beeping sound
The computer will automatically adjust the needle upper position when the machine is switch on,
and automatically adjust the needle lower position when you start sewing. Please note that it is a
normal phenomenon if you hear a sound coming from the machine (machine adjusting sound)
and feel that the sewing is being delayed. It's not dangerous to sew.
- When operating correctly: 1 beep
- When operating incorrectly: 3-short beeps
- When the sewing machine is in trouble and can't sew: 8 seconds short beeps
It means that the thread is twisted or jammed and the hand wheel axle can't move. Please look
through the "Trouble shooting guide" on page 49 to find the solution. After the problem has
been solved, the machine will continue to sew.
Note: If the problem is still not solved, please contact your local dealer.
Attention: During the sewing, if the thread get jammed inside the hook stopping the
needle from moving and you continue pressing the foot control, the security switch will
stop the machine completely. In order to restart the sewing machine, you will have to turn
the on/off switch to the OFF position and the ON again.
With the sewing machine turned off, insert the foot control
plug into its connector on the sewing machine. Turn on the
sewing machine, and then slowly depress the foot control
to start sewing. Release the foot control to stop the
sewing machine.
Note: The setting of the speed control
maximum speed of the machine.
5
lever will limit the