Electro-Voice EVU series User Manual page 20

EVU Technical Manual
To install the assembled U-Bracket to the enclosure, do the following:
NOTE: All EVU systems are assembled in the following manner:
Tools: #2 Phillips screwdriver
Remove two (2) M8 flat head screws (C) from each end of the loudspeaker enclosure (A).
1.
Position the loudspeaker enclosure inside the universal u-bracket (B).
2.
Place one (1) M8 rubber washer (D) between the enclosure's screw hole and the universal u-bracket on each side of
3.
the enclosure.
NOTE: See Figure 29 for holes specific to the system being mounted.
Securely fasten one (1) M8 panhead screw through the bracket, washer, and enclosure on each side of the
4.
assembly.
Position the loudspeaker at the desired angle.
5.
Securely tighten the M8 flat head screw.
6.
EVU-1062 Assembly—Example
FIGURE 30.
20