Power Management Setup - ECS A875M-A Manual

Onboard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
Press <Esc> to return to the main menu setting page.

Power Management Setup

This page sets up some parameters for system power management operation.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
ACPI Suspend Type
PWRON After PWR-Fail
Resume By RING
Resume By PCI/PCI-E/Lan PME
Resume By USB (S3)
Resume By PS2 KB (S3)
Resume By PS2 MS (S3)
: Move
F1:General Help
ACPI Suspend Type (S3)
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.
PWRON After PWR-Fail (Power Off)
This item enables your computer to automatically restart or return to its operating
status.
Power Management Setup
S3
Power Off
Disabled
Disabled
Disabled
Disabled
Disabled
Enter : Select +/-/: Value F10: Save
F9: Optimized Defaults
Using BIOS
Help Item
Select the ACPI
state used for
System Suspend.
ESC: Exit
33