Redundancy Enable - dbx DriveRack 480 User Manual

Section 6

6.15 Redundancy Enable

6.16 Load Stored
DriveRack™ User Manual
60
Utilities
• Use the PARAMETER 3 knob to select the desired microphone input. Mic input options
include: Ch3, Ch4 and Ch3 and 4 simultaneously. Warning - RTA will not function proper-
ly when using a microphone unless the option has been set appropriately.
The DriveRack™ units provide the user with the redundancy feature. This feature allows the
selected master unit to retain all programming information of all units used in a DriveRack™
network. This simply means that in the unfortunate event that one of the units goes out of ser-
vice, a replacement unit can be added into the network and the information from the previous
unit will be added via the master unit. For more information about Redundancy, please refer
to section 7.4. To enable this feature, use the following procedure.
• Enter the "Utility" menu by pressing the UTILITY button once.
• Press the NEXT PG or PREV PG button until page 11 is reached.
• Use the PARAMETER 1 knob to set the Redundancy feature to On. The display will appear
something like this:
The DriveRack has a non-volatile memory and can return to either the last state that it was in
or the last stored program. This parameter allows the user to set the non-volatile memory to
either recall the last saved program, or the last state that the unit was in before the unit was
shut down.
UTILITY
Program Load Modes
Parameter 1
Redundancy
Parameter 2
Load Stored
Parameter 3
Load From
p 11:11
stored Program
On
on intial startup
On
DriveRack
® ®
™