Initial Auto Installation; Checking Signal Strength And Channel Strength - Sharp Aquos LC46D65E Operation Manual

Quick guide

Initial auto installation

When the TV is powered on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Confirm the following before turning
on the power
E
Is the antenna cable connected?
E
Is the AC cord plugged in?
1
Press a on the TV.
• The initial auto installation wizard appears.
2
Setting the OSD language.
English
Italiano
Svenska
Press a/b/c/d to select the desired language,
and then press OK.
3
Selecting the location of the TV.
HOME
Press c/d to select where you will use this TV,
and then press OK.
• HOME: "STANDARD" will be the default value for the "AV
MODE" setting.
• STORE: "DYNAMIC (Fixed)" will be the default value for the
"AV MODE" setting. If the "AV MODE" is changed, the TV will
automatically switch back to "DYNAMIC (Fixed)" when there
is no signal input from the TV or remote control unit for 30
minutes.
4
Setting the country.
Austria A B/G
Finland FIN B/G
Greece GR B/G
Press a/b/c/d to select your country or area,
and then press OK.
• This setting screen only appears during the first installation.
5
Starting channel search.
Digital Search
Press c/d to select "Digital Search" or "Analogue
Search", and then press OK.
• If you want to search for more broadcasts, execute
"Additional Search" from the "Programme Setup" menu
(Pages 27 and 28).
• To watch both analogue broadcasts and digital broadcasts,
you should perform the channel search setting for each
format.
EXAMPLE
• If you execute "Digital Search" in the initial auto installation
wizard, you should perform "Analogue Search" from "Auto
Installation" under the "Setup" menu (Pages 27 and 28).
STORE
Analogue Search
6
The TV searches for, sorts and stores all the
receivable TV stations according to their settings
and the connected antenna.
To abort the initial auto installation in progress, press 6.
•
NOTE
• If you turn off the power on the TV after performing step 5,
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the "Setup" menu (Page 27).
• The initial auto installation wizard will go off if you leave
the TV unattended for 30 minutes before searching for
channels in step 6.
Checking signal strength and
channel strength
If you install a DVB-T antenna for the first time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking
the antenna setup screen.
1
Press MENU and the "MENU" screen displays.
2
Press c/d to select "Setup".
3 Press a/b to select "Antenna Setup-DIGITAL",
and then press OK.
E
Checking signal strength
Press a/b to select "Signal Strength".
Supply Voltage
Signal Strength
Channel Strength
CH No.
Signal Strength
Quality
E
Checking channel strength
Press a/b to select "Channel Strength", and
then press OK.
• You can input a specified frequency band using the 0–9
numeric buttons.
Supply Voltage
Signal Strength
Channel Strength
CH No.
Signal Strength
Quality
4
Position and align the antenna so that the
maximum possible values for "Signal Strength"
and "Quality" are obtained.
NOTE
• The values of "Signal Strength" and "Quality" indicate when
to check the appropriate alignment of the antenna.
21
Current 0 Max 0
Current 0 Max 0
4 7 4 . 0
MHz
21
Current 0 Max 0
Current 0 Max 0
9