Installation; Step 1 - Set The Option Switches; Continuous Or Trigger Play, Switch 1; Figure 3 - Option Select Switches - Avaya SoundBrick 500 Installation And Operation Manual

Step 1 – Set the option switches
Set the option select "DIP" switches to match your requirements for play mode,
bandwidth, and speaker on/off.
"off"
"on"
This example is for illustrative purposes only.
Your actual switch settings will vary.
A switch is "ON" when it is pointing TOWARDS the switch numbers. The switch is
"OFF" when it is pointed AWAY FROM the switch numbers. In the picture shown
above, switch 1 is "off" and switch 2 is "on."
Switch #
1
2-3
4
IMPORTANT NOTE: Changes to the bandwidth setting do not take effect
until power is recycled and the tape reloaded.

Continuous or Trigger Play, Switch 1

For most applications, including message on hold, message play should be set
to continuous (switch off).
continuously until the external trigger is plugged in. Momentarily activating the
trigger will play the message once.
SoundBrick 500

INSTALLATION

Figure 3 - Option Select Switches

Option
Message play
Bandwidth
Factory Test

Table 3 - Option Select Switches

If the switch is on, the message will play
Possible Values
On = Trigger play enable
Off = Continuous play (MOH)
2 Off, 3 Off = 3.5KHz/34KBps
2 On, 3 Off = 7.0KHz/69KBps
2 Off, 3 On = 7.0E KHz/92KBps
Not Used
9
01/08/2001