Samsung SRP-350PG - SRP 350 B/W Direct Thermal Printer Service Manual page 79

Second byte (printer information)
Bit Off/On Hex
0 - -
1 - -
2 - -
Off 00
3
On 08
4 Off 00
Off 00
5
On 20
Off 00
6
On 40
7 Off 00
Bit 3 : If these errors occur due to paper jams or the line, it is possible to
recover by correcting the cause of the error and executing
DLE ENQ n (1≤n≤2). If an error due to a circuit failure
(e.g. wire break) occurs, it is impossible to recover.
Bit 6 : When printing is stopped due to high print head temperature until
the print head temperature drops sufficiently or when the paper roll
cover is open during printing, bit 6 is On.
Third byte (paper sensor information)
Bit Off/On Hex
Off 00
0,1
On 03
Off 00
2,3
On 0C
4 Off 00
5,6 - -
7 Off 00
Fourth byte (paper sensor information)
Bit Off/On Hex
0-3 - -
4 Off 00
5,6 - -
7 Off 00
[Default] n=0 when DIP SW 2-1 is Off, n=2 when DIP SW 2-1 is On.
GS f n
[Name] Select font for Human Readable Interpretation(HRI) characters.
[Format] ASCII
Hex
Decimal
[Range] n = 0, 1, 48, 49
[Description] Selects a font for the HRI characters used when printing a bar code.
n selects a font from the following table :
n
0, 48
1, 49
8-16
Decimal Status for ASB
- Undefined.
- Undefined.
- Undefined.
0 No Auto-cutter error.
8 Auto-cutter error occurred.
00 Not used. Fixed to Off.
0 No unrecoverable error.
32 Unrecoverable error occurred.
0 No automatically recoverable error.
64 Automatically recoverable error occurred.
0 Not used. Fixed to Off.
Decimal Status for ASB
0 Paper roll Near-END sensor : paper adequate.
3 Paper roll Near-END sensor : paper near end.
0 Paper roll end sensor : paper present.
12 Paper roll end sensor : paper not present.
0 Not used. Fixed Off.
- Undefined.
0 Not used. Fixed Off.
Decimal Status for ASB
- Undefined.
0 Not used. Fixed Off.
- Undefined.
0 Not used. Fixed Off.
GS f n
1D 66 n
29 102 n
Font
Font A (12 ×24)
Font B (9 ×17)
Command
Samsung Electro-Mechanics