Page 2
For future reference please record the following information which can be found on the Rating Plate and the date of purchase which can be found in the invoice:...
Page 4
The aforegoing does not affect your statutory rights. The Warrantee applies to Great Britain and Northern Ireland only. In the event that you require any After Sales Service or advice, please contact the Baumatic Service Department on telephone number – 0118 933 6911 Before using this appliance ensure that the protective packaging has been removed from the machine.
Page 5
Always dispose of an appliance that is to be scrapped at the appropriate re-cycling centre, to protect the environment. Baumatic Ltd declines any responsibility for injury or damage to persons or property as a result of improper use or installation of this appliance.
Page 6
INSTRUCTIONS FOR USE BDW5 BWD5 GETTING TO KNOW YOUR MACHINE WASH PROGRAMS WASH PHASE INDICATOR LIGHTS...
Page 7
ADJUSTING THE WATER SOFTENER (see Fig. 1) ADDING REGENERATING SALT TO THE CONTAINER IMPORTANT NOTE Do not put detergent in the salt container as this will destroy the water softener.
Page 8
ADDING RINSE AID IDENTIFYING THE RINSE AID LEVEL ADDING DETERGENT LOADING THE DISHWASHER LOWER BASKET...
Page 9
USER INSTRUCTIONS The collapsible racks at the front of the tray can be used for large items. Cutlery Trays can be positioned to choice in the lower tray. Place cutlery handles downwards, apart from sharp-ended knives which for safety reasons should be placed blade down.
Page 10
USER INSTRUCTIONS If you move house or if your water supply changes, it may be necessary to adjust the water hardness settings. If in doubt, check the hardness value of the new water supply with the local Water Company. If the hardness value is above 29 degrees, it is recommended that specialist advice is obtained on whether a means of treatment for the water supply is required.
Page 11
USER INSTRUCTIONS Pre wash Cold rinse Heavily Super wash 15 + 25 soiled Normally Normal 5 + 25 soiled Lightly Economy soiled Delicate Quick wash items The amount of detergent shown is for non-concentrated type in powder or tablet form. For concentrated or liquid detergent, please refer to the detergent manufacturer’s recommendations.
TROUBLESHOOTING INDICATION PROBLEM SOLUTION (FLASHING SYMBOLS) POSSIBLE CAUSE PROBLEM The dishwasher does not start No water is entering the appliance Dishes are not cleaned properly...
INSTRUCTIONS FOR THE INSTALLER Building Regulations Building standards IEE Wiring Regulations Electricity at Work Regulations UK Water Bylaws and EN50084 POSITIONING THE APPLIANCE PRE-COMMISSIONING THE APPLIANCE INSTALLATION NOTES...
Page 15
INSTALLATION INSTRUCTIONS Fig. 12 Fig. 13 Fig. 14 Fig. 15 Fig. 16 The standpipe must have an internal diameter of at least 40mm to allow an air gap between the drain hose and the standpipe. It is a mandatory requirement that the standpipe is installed in such a way that the end of the drain hose cannot be covered with water.
Page 16
INSTALLATION INSTRUCTIONS Before connecting the appliance, make sure that the supply voltage marked on the Rating Plate corresponds with the mains supply voltage. This appliance is fitted with a moulded-on 13A plug top for connection to a socket outlet. If the location of the appliance requires removal of the plug, this must be performed by a competent person in accordance with the procedure below.
Page 17
Height 820 to 870mm (adjustable) Width 595mm Depth 555mm (excluding the décor door) Rated Voltage 230/240V ac 50Hz Supply Connection 13A (socket outlet or double pole switched fused outlet with 3mm contact gap) Rated Power Input 2550W Mains Supply Lead 3 x 1.5mm²...
Page 18
The conditions of the guarantee, which applies, to your Baumatic appliance are as follows: All ‘Work’ in relation to the Guarantee must be carried out by Baumatic Ltd or an approved service agent of Baumatic Ltd. Any claims made under the terms of the guarantee must be supported by the original invoice / bill of sale issued at the time of purchase.