Dependencies And Requirements - Nas E7000 As A Single Device; Storage Object Requirements; Storage Networking Requirements; Ip Networking And Setup Requirements - Compaq 230038-001 - StorageWorks NAS Executor E7000 Model 902 Server Quick Start Manual

NOTE: Maps in a cluster are replicated across both nodes in a cluster.
7. Read the remaining sections of the administration guide, especially the cluster
management section.
Dependencies and Requirements - NAS E7000 as a
Single Device
The following conditions must be met in order for the NAS E7000 to operate as a
single device.

Storage Object Requirements

•
MA8000, MA12000, and MA16000-based storage only
•
ACS firmware (families 8.5 and 8.6 only)
•
SAN-based storage composed of RAID 3/5 RAIDsets
NOTE: All RAIDsets are supported, but it is recommended that you use RAID 3/5 for the
best combination of availability, performance, and space efficiency.

Storage Networking Requirements

•
One open port on each of the two SAN switches that access the same controller
pairs
•
Two fibre channel cables

IP Networking and Setup Requirements

•
A single Ethernet connection on a switch or hub for the RILOE board
NOTE: The RILOE board connection is optional, but recommended.
•
A single Ethernet connection for the management subnet of the NAS E7000
Compaq StorageWorks NAS Executor E7000 Quick Start Guide
Product Overview
1-11