AT&T IPC-1600 User Manual page 65

Installation Procedures
Once the kernel has been rebuilt, another message displays:
Confirm
To complete the install/remove process a shutdown is now
b e i n g i n i t i a t e d a u t o m a t i c a l l y .
Make sure your floppy drive is empty. If you are
installing or removing controller boards, you may power
down the system after the shutdown has completed.
Strike ENTER when ready
or ESC to stop.
Remove the "Intelligent Ports Card (IPC-1600) UNIX System V/386
Device Drivers, Version 1.0." diskette from the diskette drive and properly
store the diskette.
Press ENTER. This automatically shuts down the system. You may now
proceed to the hardware phase of installation.
After you have completed the hardware phase of installation (Chapter 4),
you will need to power up the system, which will boot the UNIX system.
When the system reboots, a new kernel environment is set up and the
board(s) will be fully installed.
3-18 IPC-1600 USER'S GUIDE