AT&T IPC-1600 User Manual page 162

Hardware Installation,
Connect the 16-Ports Fanout Module Cables, 4-4
Connect the Ribbon Cables to the IPC-1600, 4-5
Install the Board, 4-6
Introduction, 4-1
Preparation, 4-2
Hardware Parameter Settings,
DS1 Switch Settings-Controller Memory Starting Address, A-3
DS1 Switch Settings-I/O Port Address, A-8
DS2 Switch Settings-Interrupt Request Level, A-10
Local Program Memory Size Select Jumper J1, A-12
Sample Configuration Record, A-13
Switch, Jumper, Connector Location Information, A-1
Headers,
P3 and P4, B-3
Helpful Hints, 7-10
Hexadecimal Notation, 1-8
Install the Board, 4-6
Installation Information,
Choosing a Mounting Location, C-3
Connecting Port Modular Cables, C-4
General Instructions, C-2
Installing the 16-Ports Fanout Module, C-4
Routing and Connecting Ribbon Cables to the Fanout Module, C-3
Securing the Wire-Frame Assembly, C-3
Installation Procedure,
Create or Modify the
Execute IPC16CNF to Configure the Driver, 2-7
Install the Hardware, 2-4
Load the Software, 2-4
Preconfigure the IPC-1600 Boards, 2-3
Reboot the System, 2-14
H
I
C O N F I G . S Y S
Index
File, 2 - 6
INDEX IN-3