Specify The Number Of Boards - AT&T IPC-1600 User Manual

Installation Procedures

Specify the Number of Boards

You are then asked to specify the number of boards to be installed as
follows. Remember that the number of boards indicated in the example is
dynamic with respect to the system type and available system configuration
resources.
The current system configuration will allow for up to 7
IPC-1600 controller boards to be installed. How many IPC-1600
c o n t r o l l e r b o a r d s w i l l y o u b e i n s t a l l i n g ?
(1-7, Q to quit)
Enter the number of boards that you are installing; remember to note this
number so that when you install the hardware you will be able to refer to this
record. Press the ENTER key after typing the number of boards.
For each board, you will be asked to specify the following sequence of
information:
Hardware Interrupt ReQuest (IRQ) level
Starting I/O address
Starting controller memory address.
After you specify these three items of data, you will be asked to confirm
your choices for the board. If you specified to share an interrupt level among
all IPC-1600 boards, the IRQ question is omitted from the loop. If you
specified to share the controller memory address among all IPC-1600 boards,
the starting controller memory address question is omitted from the loop.
3-10 IPC-1600 USER'S GUIDE