Ai Net2; Peg Link Mode - Asus P5N32-SLI Premium User Manual

4.4.2

AI NET2

Advanced
POST Check LAN Cable
POST Check LAN2 Cable
Pair
LAN1(1-2)
LAN1(3-6) 3-6)
LAN1(4-5) 4-5)
LAN1(7-8) 7-8)
LAN2(1-2) 1-2)
LAN2(3-6) 3-6)
LAN2(4-5) 4-5)
LAN2(7-8)
F1:Help
ESC: Exit
POST Check LAN Cable [Disabled]
POST Check LAN2 Cable [Disabled]
Allows you to enable or disable LAN cable check during POST. When enabled, the
menu reports the cable faults or shorts, and displays the point (length) where the
fault or short is detected. Configuration options: [Disabled] [Enabled]
4.4.3

PEG Link Mode

Advanced
PEG Link Mode
PEG Link Mode [Auto]
Sets the PCI Express graphics link mode. Setting this item to [Auto] allows the
motherboard to automatically adjust the PCI Express graphics link mode to the
correct frequency based on the system configuration. Three additional settings
are available for overclocking the PEG Link Mode. Configuration options: [Auto]
[Disabled] [Normal] [Fast] [Faster]
-
Phoenix-Award BIOS CMOS Setup Utility
AI NET2
Status Length
Open 0.0M
Open Open 0.0M 0.0M
Open Open 0.0M 0.0M
Open Open 0.0M 0.0M
Open Open 0.0M 0.0M
Open Open 0.0M 0.0M
Open Open 0.0M 0.0M
Open 0.0M
↑↓
: Select Item
→← : Select Menu
Phoenix-Award BIOS CMOS Setup Utility
PEG Link Mode
[Disabled]
[Disabled]
-/�: Change Value
Enter: Select SubMenu
[Auto]
Select Menu
Item Specific Help
Enable or disable LAN
cable check during POST.
F5: Setup Defaults
F10: Save and Exit
Select Menu
Item Specific Help
Press <Enter> to
Enable/Disable PCI
Express graphics card
over-clocking by
accelerating PCI-Ex
connecting mode and
determine the speed
level on it.
Chapter : BIOS setup