Dimmer; Speed - Alfa Romeo GT Owner's Manual

DIMMER

With this function it is possible to adjust
the lighting (dimming/brightening) of the
instrument cluster, mileage recorder (total,
trip meter), headlight aiming display, radio
display, radio navigator display (where pro-
vided) and two-zone climate control (where
provided).
Proceed as follows:
❒ press briefly button MODE: the display
will show a graduated scale;
❒ press buttons ▲/▼ to adjust as re-
quired.
Partial lighting
Keeping button (▼) pressed for more than 4
seconds, the rev counter lighting is turned off.
Keeping button (▲) pressed for more than
4 seconds, the complete instrument cluster
lighting is turned on again.
IMPORTANT When external lights are
switched on dimming of the brightness can
be perceived. In the event of any faults,
lighting adjustment (rheostat) is not possi-
ble and the display is shown at its maximum
brightness.
64

SPEED

With this function it is possible to set the
car speed limit (km/h or mph), when this
limit is exceeded the driver is immediately
alerted (see section "Warning lights and mes-
sages").
To set the speed limit, proceed as follows:
❒ press briefly button MODE: the display
will show the word ON;
❒ press briefly button MODE then, use
buttons ▲/▼ to set the required speed
(during setting the value flashes).
❒ press briefly button MODE to go back
to the menu screen or press the button
for long to go back to the standard
screen.
IMPORTANT The possible setting is be-
tween 30 and 250 km/h or between 20
and 150 mph depending on the unit set pre-
viously (see paragraph "UNITS" described
later). Every press of the button ▲/▼ in-
creases or decreases by one unit. Keeping
button ▲/▼ pressed, obtain automatic fast
increase/decrease. When you are near the
required setting release the button and com-
plete adjustment with single presses.
To clear setting:
❒ press briefly button MODE: the display
will show the word OFF;
❒ press button (▼): the display will show
the word OFF;
❒ press briefly button MODE to go back
to the menu screen or press the button
for long to go back to the standard
screen.