Table of Contents
Advertisement
1
Getting Started
Chassis Installation
12
Table 1-1 SSI connector pin description
SSI timing signal
CLK10M
STAR_TRIG
GA0,GA1,GA2
The L- Mount kit is to be installed to your U2741A module.
The following instructions describe the simple procedure of
installing the L- Mount kit and your module in the chassis.
1 Unpack the L- Mount kit from the packaging.
2 Remove your U2741A module from the bumper casing.
3 Use a Phillips screwdriver to fasten the L- Mount kit to
your U2741A module.
4 Insert your U2741A module into the U2781A chassis with
the 55- pin backplane connector positioned at the bottom
of the module.
5 Once you have slotted in the module, tighten the screws
of the L- Mount kit to secure the connection.
Functionality
10 MHz clock source
Star trigger
Geographical address pin
U2741A User's Guide
Advertisement
Table of Contents
