2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse.
Figure 32. Mouse connectors
4. Disconnect the failing mouse cable from the computer.
5. Connect a new mouse cable to the appropriate connector on the computer.
6. Go to "Completing the parts replacement."
Completing the parts replacement
After completing all parts replacements, you need to reinstall the computer cover
and reconnect cables, including telephone lines and power cords. Depending on
the parts replaced, you might need to confirm the updated information in the
Setup Utility program. Refer to Chapter 4, "Using the Setup Utility," on page 49.
To close the computer cover and reconnect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
36
User Guide
Note: Your mouse might be connected to a standard mouse connector 1 or a
USB connector 2 . Depending on where your mouse is connected, see
"Locating connectors on the rear of your computer" on page 7 or
"Locating connectors on the front of your computer" on page 6.
or loose screws are left inside your computer. See "Locating components" on
page 9 for the location of various components.