Ir Transmitter Adjustments (Ccd-Trv43/Trv46/Trv46Pk); Ir Video Carrier Frequency Adjustment (Vc-215 Board); Ir Video Deviation Adjustment (Vc-215 Board) - Sony CCD TRV16 - Hi8 Handycam Camcorder Service Manual

3-5. IR TRANSMITTER ADJUSTMENTS
(CCD-TRV43/TRV46/TRV46PK)
Adjust using a IR receiver jig (J-6082-383-A).
Switch setting:
LASER LINK .................... (Red LED is lit)

1. IR Video Carrier Frequency Adjustment (VC-215 board)

Mode Camera standby
Subject Arbitrary
Pin 5 of CN003 of IR receiver jig (RF)
Measurement Point
( Or Pin !§ of IC751 of VC-215 board)
Measuring Instrument Frequency counter
Adjustment Page F
Adjustment Address 68
Specified Value f = 11.85±0.05MHz
Connection of Equipment
Connect the measuring device as shown in the following figure,
and adjust.
Main unit IR receiver jig
Fig. 5-3-17.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 01, set data: 37, and press the PAUSE
button of the adjusting remote commander.
3) Select page: F, address: 68, change the data, and set the video
carrier frequency (f) to the specified value.
4) Press the PAUSE button of the adjusting remote commander.
5) Select page: 3, address: 01, set data: 00, and press the PAUSE
button of the adjusting remote commander.
6) Select page: 0, address: 01, and set data: 00.
Frequency counter
Pin 5
of CN003

2. IR Video Deviation Adjustment (VC-215 board)

Mode Camera standby
Subject Arbitrary
Measurement Point VIDEO OUT terminal of IR receiver jig
(Terminated at 75Ω)
Measuring Instrument Oscilloscope
Adjustment Page F
Adjustment Address 66
Specified Value A = 0.87±0.04V
Connection of Equipment
Connect the measuring device as shown in the following figure,
and adjust.
IR receiver jig
Main unit
VIDEO
OUT
Fig. 5-3-18.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 01, set data: 39, and press the PAUSE
button of the adjusting remote commander.
3) Select page: F, address: 66, and change the data, set the video
signal amplitude (A) to the specified value.
4) Press the PAUSE button of the adjusting remote commander.
5) Select page: 3, address: 01, set data: 00, and press the PAUSE
button of the adjusting remote commander.
6) Select page: 0, address: 01, and set data: 00.
H
Fig. 5-3-19.
Oscilloscope
75 Ω
75 Ω (1-247-804-11)
A