Removing Memory Cards; Protecting Memory Cards - Panasonic AG-AC130A Operating Instructions Manual

„
DV mode
• Use a memory card of SD speed class 6 or above when recording with DV mode. Recording cannot be
performed with a memory card of lower than SD speed class 6.
• Control space is included in the displayed capacity, and available recording capacity will be smaller than
that.
• Continuous recording time is a maximum of 12 hours (when using the AC adaptor).
• The recording time of a memory card may shorten when record and delete are repeated often over and
over. In that case, format the memory card with the camera. When a memory card is formatted, all data
recorded on the memory card is erased and cannot be restored. Save important data to your computer.
• Partition of clips recorded on a memory card
When an SDHC memory card of 8 GB or above is used, if the recording space of a single clip exceeds
4 GB, it is automatically saved as a separate clip. Saved data can be manipulated as a single clip during
thumbnail operation of the camera. When handled with nonlinear editing software or a computer, clips
are handled as the separate clips.

Removing memory cards

1
Slide the <OPEN> lever of the memory card
slot cover down to open the cover.
• Ensure that the memory card access lamp is
not flashing orange before opening the cover.
2
Press the center of the memory card, and
pull the memory card straight outwards.
Memory card access lamp
• Do not remove the memory card or switch
off the power at the following times, because
doing so may damage the memory card.
- After inserting a memory card, while the
orange memory card access lamp is still
flashing until it changes to illuminated.
- While the memory card access lamp is
flashing such as during shooting or during
shooting finalization.

Protecting memory cards

Move the write-protect switch on the memory
card to the <LOCK> position to prevent recorded
content from being accidentally erased from the
memory card.
Write-protect
switch
32
15