Installing Devices With Ir Interface; Installing Devices With Infrared Interface - Texas Instruments TravelMate 5000 Series Maintenance Manual

2.6.6
Any device with an Infrared interface conforming to IRDA specifications may
be placed adjacent to the IR connector on the notebook (two IR interfaces
must face each other) as shown in Figure 2-16.
Range:
Angle:
Wavelength:
Backlight envir:
Line of sight:
Comm Parameters: 115Kbaud, 8 data bits, odd/even/no
Modes Supported:
Figure 2-16 Installing Devices with Infrared Interface
2-18 Installation

Installing Devices With IR Interface

Note: Any device equipped with Infra-Red interface
conforming to IRDA Specifications may be placed adjacent to the
IR Interface on the Notebook (line of sight).
Infra-Red
Interfaces
SPECIFICATIONS
6 inches to 3 feet
+/- 15 degrees
875 nm
Typical indoor environment
Bi-directional, half duplex
Parity, stop bit.
Infra Red Data Assn. (IrDA);
Hewlett-Packard (HPSIR)