Post Error Indicators; Post Error Message - Acer Aspire 5910 Service Manual

Notebook computer
Hide thumbs Also See for Aspire 5910:
Table of Contents

Advertisement

POST Error Indicators

When POST detects a system failure, it either displays a POST error message, or emits a series of beep
codes.

POST Error Message

Whenever a non-fatal error occurs during POST, an error message describing the problem appears onscreen.
These text messages are displayed in normal video (white text on black background). It shows the details of
the error.
The POST error message index in this section lists the error messages and their possible causes. The most
likely cause is listed first. The listed error symptoms classified by function.
NOTE: Perform the FRU replacement or actions in the sequence shown in FRU/Action column, if the FRU
replacement does not solve the problem, put the original part back in the computer. Do not replace a
non-defective FRU.
This index can also help you determine the next possible FRU to be replaced when servicing a computer.
If the symptom is not listed, see "Undetermined Problems" on page 79.
NOTE: Most of the error messages occur during POST. Some of them display information about a hardware
device, e.g., the amount of memory installed. Others may indicate a problem with a device, such as
the way it has been configured.
IMPORTANT: If the system fails after you make changes in the Setup Utility menus, reboot the computer,
enter Setup, then press F9 to load the Setup defaults to correct the error.
Error Code List
Error Code
006
010
070
071
072
110
<No error code>
<No error code>
Chapter 1
Error Message
Equipment Configuration Error
Causes:
1. CPU BIOS Update Code Mismatch
2. IDE Primary Channel Master Drive Error
(The causes will be shown before the Equipment
Configuration Error message)
Memory Error at xxxx:xxxx:xxxxh (R:xxxxh, W:xxxxh)
Real Time Clock Error
CMOS Battery Bad
CMOS Checksum Error
System disabled.
Incorrect password is specified.
Battery Critical Low
In this situation BIOS will issue four short beeps, then shut
down the system, no message will show.
Thermal Critical High
In this situation BIOS will shut down the system, no
message will show.
67

Advertisement

Table of Contents
loading

Table of Contents