Door Reversal - Electrolux EU8216C Instruction Booklet

Door Reversal

1. Close the cabinet and disconnect the appliance
from the electricity socket.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Reposition it and
transfer to the opposite side.
3. Support the cabinet on a wooden block when it is
laid down. This will make it easier to grip under the
cabinet when resupporting to an upright position.
4. On the upper part of the cabinet. Remove the
hinge pin and replace on the other side.
5. On the lower part of the cabinet.
a Unscrew the hinge.
b Remove the door-closing fittings from the hinge
and put the hinge pin on the other side. Then attach
the supplied door-closing fitting.
6 a. Remove the door-closing fitting from the bottom
of the door.
b. Remove the plastic plug from the corresponding
hole on the other side. Use a screwdriver to rock the
plug loose. Then secure the supplied door-closing
fitting.
c. Secure the lower hinge.
7. Raise the cabinet and replace the ventilation grille.
8. Unscrew the handle. Carefully press in the plastic
plugs on the opposite side using a punch. Secure the
handle in the plug holes. Then press the supplied
plastic plugs into the holes to which the handle was
previously fitted.
9. Put the cabinet in position. Check that it stands
straight. See the section "Positioning the cabinet".
1
2
3
4
5 a
6
8
15
5 b
b
a
c
Electrolux 8181499--02/4