Table of Contents
Advertisement
Attaching/Removing the Battery
The camera can run with the battery power only. When the battery (BN-VG139U) (sold separately) is attached,
videos can be transmitted/recorded even in places where the AC adapter cannot be used.
• The battery cannot be used when the pantilter is attached.
• Turn off the power before attaching/removing the battery.
• The following cannot be used while the battery is attached:
– LAN terminal, network mode switch, reset button
CAUTION
• Be sure to use a battery of our manufacture. If a battery not of our manufacture is used, the safety and
performance are not guaranteed.
• Charging may take time or may not be possible in places outside the operating temperature range.
Attaching
Insert the battery deeply, and then slide it to the right
until it clicks.
Removing
Slide the battery to the left, and pull it out toward you
while pushing in the lever below the battery.
Charging
Connect the adapter to the DC connector of the
camera, and turn off the power. Charging starts.
The power button of the camera blinks during charging.
The power button turns off when charging is complete.
Approximate charging times
BN-VG139U (sold
6 hr. 10 min.
separately)
Approximate recording times
shooting time
BN-VG139U (sold
1 hr. 55 min.
separately)
Charging time
Actual
Continuous
shooting time
2 hr. 55 min.
29
Advertisement
Table of Contents
