General Care & Cleaning - Kenmore 9742 - 30 in. Electric Range Use And Care Manual

General Care & Cleaning
• Changing the Oven Light(s)
Oven
Light
Wire
Holder
Changing the Oven Light (s)
The oven light(s) automatically turn ON when the oven door is opened. The
oven light(s) may also be manually operated by pressing the _ pad.
The oven light bulb(s) are located at the rear of the oven and covered with a
glass shield held by a wire holder. The glass shield(s) must be in place
whenever the oven is in use.
To replace the oven light bulb:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced
glove for protection against possible broken glass.
Care and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions.
38