Surface Cooking - Kenmore 9742 - 30 in. Electric Range Use And Care Manual

Surface Cooking
Using Turbo Boil
TM
Element (some models)
The Turbo BoilTMfeature uses a higher wattage surface radiant element which can bring food
items to boil much quicker. The left front radiant element will be clearly marked if this feature is
available on your range (See Fig. 1). If equipped with the Turbo Boil
TM
feature, place the
cookware on the left front surface element and follow the instructions "To Operate a Single
Radiant Element" in the Settings Surface Controls section.
i!
TM
::
1_ Be Bo_ z
/ N
Fig. 1
Using proper cookware
The size and type of cookware used will influence the setting
needed for best cooking results. Cookware should have flat
bottoms that make good contact with the entire surface heating
element (See Fig. 2). Check for flatness by rotating a ruler across
the bottom of the cookware (See Fig. 3).
Cookware Material Types
The cookware material determines how evenly and quickly heat is
transferred from the surface element to the pan bottom. The most
popular materials available are:
ALUMINUM = Excellent heat conductor. Some types of food will
cause it to darken (Anodized aluminum cookware resists staining &
pitting). If aluminum pans slide across the ceramic cooktop, they
may leave metal marks which will resemble scratches. Remove
these marks immediately.
COPPER - Excellent heat conductor but discolors easily. May leave
metal marks on ceramic glass (see Aluminum above).
STAINLESS STEEL = Slow heat conductor with uneven cooking
results. Is durable, easy to clean and resists staining.
CAST IRON = A poor heat conductor however will retain heat very
well. Cooks evenly once cooking temperature is reached. Not
recommended for use on ceramic cooktops.
PORCELAIN-ENAMEL on METAL - Heating characteristics will
vary depending on base material. Porcelain-enamel coating must
be smooth to avoid scratching ceramic cooktops.
GLASS - Slow heat conductor. Not recommended for ceramic
cooktop surfaces because it may scratch the glass.
*CORRECT INCORRECT
t t
• Flat bottom and straight
sides.
• Tight fitting lids.
• Weight of handle does not
tilt pan. Pan is well
balanced.
• Pansizes match the
amount of food to be
prepared and the size of
the surface element.
• Made of a material that
conducts heat well.
• Easyto clean.
® Always match pot diameter
to element surface
diameter.
Fig. 2
Be sure to follow the
recommendations for using
proper cookware as illustrated
in Figs. 4 & 5. For more
information about the ceramic
cooktop see "Cooktop
Cleaning & Maintenance" in
the General Care & Cleaning
section.
e Curved and warped pan
bottoms.
÷1 I_-
• Pan overhangs element b
more than one-half inch.
w
÷1 I_
® Pan is smaller than
element.
• Heavy handle tilts pan
Fig. 3
Important Note: DO NOT place EMPTY
aluminum, glass or porcelain-enamel
coated cookware on the ceramic cooktopY
The melting point of cookware made with these
materials may be reached quickly especially if
left empty & they may bond to the ceramic
cooktop. If the cookware melts it WILL damage
the cooktop! BE SURE to follow ALL the
cookware manufacturer's suggestions when
using ANY type of cookware on the ceramic
cooktop.
11