GE RN328HSA Owner's Manual page 13

14 SCREW IN PARTWAY
Drive a mounting screw (from the hardware packet)
partway into each center of the narrow neck of the
keyhole slots marked on the cabinet bottom.
OPTIONAL POWER CORD
15
KIT JXHC1
An optional Power Cord Connection Kit, model
JXHC1, is available at extra cost from your GE
supplier for installation using a standard 3-prong,
grounded wall outlet. Follow the Installation
Instructions packed with the kit to connect the
power cord to the range hood.
C L
"
7 3 ⁄
4
NOTE: If using optional Power Cord Kit JXHC1,
feed the power cord through the hole in the top
cabinet while raising the hood. Loop any excess
length of cord and tie away with a suitable tape
or tie.
16 FEED IN WIRES
Lift the hood into position and feed the house
wiring through the wiring knockout.
Installation Instructions
Cabinet
3-prong
wall outlet
(if using cord
"
1 1 ⁄
4 connection)
" dia. clearance hole
1 3 ⁄
4
for optional power
supply location
13
17 SECURE HOOD
Slide the hood back against the wall. Tighten
the mounting screws. Be sure the screw heads
are in the narrow neck of the keyhole slot.
NOTE: DO NOT PUSH ON FAN BLADE. Pushing
on the blade may cause it to interfere with other
hood parts.
18 CONNECT DUCTWORK TO
HOOD
(Ducted installations only)
On 7" round installations, attach the 7" duct
with sheet metal screws through the holes in
the alignment ears.
Attachment ear tabs
Use duct tape to make joints secure and air tight.
Duct tape
Mounting
screw (4)
Keyhole (4)
7" round duct