GE RN328HSA Owner's Manual page 10

REMOVE EXHAUST ADAPTOR
2
If exhausting/venting using the 3
duct—optional for JV338, JV347, JV348 and JV367
models only:
Remove the exhaust adaptor from the inside of the
hood. Set it aside along with its mounting screws.
" x 10"
3 1 ⁄
4
rectangular
exhaust
adaptor
and screws
3 REMOVE FILTER
Remove the shipping tape holding the metal grease
filter in place. Pull down on the center of the front
edge of the filter. The filter will then slip out of the
retaining tabs on the back.
Metal grease filter
REVERSE THE BAFFLE FOR
4
DUCTED INSTALLATIONS ONLY
(JV347, JV348 and JV367 models)
If the hood is to be recirculated, skip to the next step.
Remove the baffle from the top of the hood. Re-install
the baffle so the short side marked "VENTED" is
visible. The long side of the baffle should be inside
the hood.
"VENTED" is visible
Installation Instructions
" x 10" rectangular
1 ⁄
4
10
REMOVE WIRING COVER
5
Remove the wiring cover from inside the hood.
Set the cover and its mounting screw aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
6
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Top knockout Back knockout
Strain relief
clamp
7 REMOVE DUCT KNOCKOUT
If recirculating, non-vented ductless (JN327 and RN328,
and optional for JV347, JV348 and JV367 models only),
skip to Step 10 D and proceed.
Using a flat blade screwdriver, remove the appropriate
duct knockout from the top or back of the hood.
" x 10" Rectangular
3 1 ⁄
4
vertical discharge.
Remove top rectangular
duct knockout only.
Strain relief
clamp
7" Round vertical
discharge. Remove circular
duct knockout only.
" x 10" Rectangular
3 ⁄
1
4
horizontal discharge. Remove
rear rectangular duct knockout only.