Advertisement
S
F
P
E
C
I
L
HD-SDI Input Board for the PT-DW10000
This board is designed for use with the DLP™ projector PT-DW10000. It enables the input of a HD-SDI (SMPTE
292M) and dual link HD-SDI (SMPTE 372M). Remote control of the projector is also possible from an external com-
puter connected via LAN.
Specifications
Power supply:
Power consumption:
Terminals:
Link A/Link B input:
Dimensions (W x H x D):
Weight:
Operating temperature:
Operating humidity:
Dimensions
DLP and the DLP logo are trademarks of Texas Instruments. All other trademarks are the property of their respective trademark owners.
As of February 2008
E
NOTE: Please use the module only on the Panasonic DLP™ projector PT-DW10000.
Provided from the DLP™ projector
Projector power consumption increases approximately 10 W
BNC x 1 for each
SD-SDI signal (YC
SMPTE 259M compliant: 480i, 576i
Single link HD-SDI signal (YC
SMPTE 292M compiant: 1720/50p, 720/60p, 1080/50i, 1080/60i, 1080/25p,
1080/24p, 1080/24sF, 1080/30p
Dual link HD-SDI signal (RGB 4:4:4 12 bit/10 bit)
SMPTE 372M compiant: 1920 x 1080/50i, 1920 x 1080/60i, 1920 x 1080/25p,
1920 x 1080/24p, 1920 x 1080/24sF, 1920 x 1080/30p
Dual link HD-SDI signal (X´Y´Z´ 4:4:4 12 bit)
2048 x 1080/24p, 2048 x 1080/24sF
204 x 32 x 214 mm (8-1/32˝ x 1-1/4˝ x 8-7/16˝)
250 g (8.8 oz)
0°C – 45°C (32°F – 113°F)
10% – 80% (no condensation)
(8-1/32˝)
Weights and dimensions shown are approximate. Specifications subject to change without notice.
ET-MD100SD4
C
4:2:2 10 bit)
B
R
C
4:2:2 10 bit)
B
R
NOTE: Use connection cables of 5CFB or higher (ex. 5CFB, 7CFB, 5CFTX, etc.).
204
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
< 1 >
Advertisement
