Advertisement
S P E C
F I L E
HD-SDI/SD-SDI Board for DLP™ Projector
This board is designed for use with the DLP™ projectors. It enables the input of a HD digital serial component
signal (SMPTE292M-compliant). Remote control of the projector is also possible from an external computer
connected via LAN.
Specifications
Power supply:
Power consumption:
Terminals:
Serial input:
Serial output:
LAN:
Dimensions (W x H x D):
Weight:
Operating temperature:
Operating humidity:
NOTE: Use connection cables of 5CFB or higher (ex. 5CFB, 7CFB, 5CFTX, etc.).
Dimensions
unit: mm
(Dimensions given in inches are approximate.)
As of December 2006
NOTE: Please use the module only on the specified Panasonic DLP™ projector.
Provided from the DLP™ projector
Projector power consumption increases approximately 10 W
BNC x 1
4:2:2 digital serial component signal: SMPTE 259M compliant,
480i, 576i
HD digital serial component signal: SMPTE 292M compiant,
720/60p, 720/50p, 1035/60i, 1080/60i, 1080/50i,
1080/25p, 1080/24p, 1080/24sF, 1080/30p
BNC x 1, active through
RJ-45 x 1, 10Base-T/100Base-TX for network connection
204 x 32 x 214 mm (8-1/32˝ x 1-1/4˝ x 8-7/16˝)
290 g (10.2 lbs.)
0°C – 40°C
10% – 80% (no condensation)
720/50p signals can be input only when this unit is used with the PT-DW10000, PT-D10000,
PT-DW7000 or PT-D7700.
(8-1/32˝)
ET-MD77SD3
Weights and dimensions shown are approximate.
Specifications subject to change without notice.
DLP and DLP logo are trademarks of Texas Instruments.
204
Note: This illustration is not drawn to scale.
4
Advertisement
