Table of Contents
Advertisement
Installing the Server Blade and Options
Preparation Procedures
To install server blade options, you may need to complete the following procedures:
•
Access internal server blade components
— Power down the server blade
— Remove the server blade from the server blade enclosure
— Remove the access panel
•
Identify the system board components
•
Install server blade options
•
Reinstall the access panel
Accessing Internal Server Blade Components
To access internal server blade components, you must remove the access panel.
Observe the following warnings and cautions.
WARNING: To reduce the risk of electric shock, do not operate the server
blade without the access panel.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Electrostatic discharge can damage electronic components. Properly
ground yourself before beginning any installation procedure. Refer to Appendix B,
"Electrostatic Discharge," for more information.
2-2
Compaq ProLiant BL20p Server Blade Setup and Installation Guide
Advertisement
Table of Contents
