Normal Mode With Triple Watch Or Dual Watch; Scan Mode Operation; Using The Radio In Scan Mode - Uniden MHS126 Owner's Manual

Normal mode with Triple Watch or Dual Watch

If you activate Triple Watch while operating in Normal
mode, the radio checks channels 16 and 9 every two
seconds; with Dual Watch turned on, the radio only
checks channel 16. The radio will not check channels 16
or 9 while you are actively transmitting; it waits until your
transmission is finished and then checks the channels.
Every 2 seconds, the radio
checks channels 9 & 16.
Triple Watch on

Scan mode operation

You can save channels into memory and then use Scan
mode to monitor those channels from lowest to highest. If
the radio detects a signal on a channel, it stays on that
channel as long as the signal is received; when the signal
stops, the radio continues scanning.
When it detects a signal, the radio stays
on the channel until you press the
Channel Up button or the signal stops.
08 10
The radio scans about
5 channels in 0.5 seconds.

Using the Radio in Scan Mode

Š To activate Scan mode, press
E-12
Monitoring Channel 25
09 16 09 16
11 12 13
Uniden MHS126 Radio Owner's Manual
09 16
Resume
scan
14 15
SCAN/DUAL
17
.