Asus P5GD1-VM Instructions Manual page 40

7 . 7 . 7 . 7 . A T X p o w e r c o n n e c t o r s ( 2 4 - p i n E A T X P W R 1 , A T X p o w e r c o n n e c t o r s ( 2 4 - p i n E A T X P W R 1 , A T X p o w e r c o n n e c t o r s ( 2 4 - p i n E A T X P W R 1 ,
7 . A T X p o w e r c o n n e c t o r s ( 2 4 - p i n E A T X P W R 1 , A T X p o w e r c o n n e c t o r s ( 2 4 - p i n E A T X P W R 1 ,
4 - p i n A T X 1 2 V 1 ) 4 - p i n A T X 1 2 V 1 ) 4 - p i n A T X 1 2 V 1 )
4 - p i n A T X 1 2 V 1 ) 4 - p i n A T X 1 2 V 1 )
These connectors are for ATX power supply plugs. The plugs from the
power supply are designed to fit these connectors in only one
orientation. Find the proper orientation and push down firmly until the
connectors completely fit.
®
P5GD1-VM ATX power connectors
Important notes on the motherboard power requirements Important notes on the motherboard power requirements Important notes on the motherboard power requirements
Important notes on the motherboard power requirements Important notes on the motherboard power requirements
•
•
•
•
•
1 - 3 0 1 - 3 0
1 - 3 0 1 - 3 0 1 - 3 0
+12V DC
Do not forget to connect the 4-pin ATX +12 V power plug;
otherwise, the system will not boot up.
To power the motherboard, it is recommended that you use an ATX
12 V Specification 2.0 power supply unit (PSU) with a minimum
350 W power rating. This PSU type has a 24-pin and 4-pin ATX
power plugs.
If you intend to use a PSU with a 20-pin and 4-pin power plugs,
make sure that the 20-pin power plug can provide at least 15A on
+12 V and that the PSU has a minimum power rating of 350 W. The
system may become unstable or may not boot up if the power is
inadequate. We do not, however, recommend the use of a 20-pin
PSU.
The ATX 12 V 350 W Spec. 2.0 PSU passed the motherboard power
requirement test with the following configuration:
CPU :
Memory :
Grpahics card :
Parallel ATA devices :
Serial ATA device :
Optical drives :
You must install a PSU with a higher power rating if you intend to
install additional devices.
ATX12V1
+3 Volts
GND GND
+12V DC +12 Volts
+12 Volts
+5V Standby
Power OK
+5 Volts
+5 Volts
+3 Volts
+3 Volts
Intel ® Pentium ® 4 3.6 GHz
512 MB DDR2 (x 4)
PCI Express x16 Nvidia EN5900
IDE hard disk drive (x 2)
SATA hard disk drive
CD-ROM (x 2)
C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n
C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n
EATXPWR1
Ground
+5 Volts
+5 Volts
+5 Volts
-5 Volts
Ground Ground
Ground
Ground Ground
PSON#
Ground Ground
-12 Volts
+3 Volts