Asus P5GD1-VM Instructions Manual page 36

3 . 3 . 3 . 3 . P C I I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ P C I I D E 1 ) P C I I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ P C I I D E 1 ) P C I I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ P C I I D E 1 )
3 . P C I I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ P C I I D E 1 ) P C I I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ P C I I D E 1 )
This connector is for an Ultra DMA 133/100/66 signal cables. The IDE
connector supports up to two IDE devices (optical drive and hard disk
drive).
P5GD1-VM PCI IDE connector
•
•
•
•
1 - 2 6 1 - 2 6
1 - 2 6 1 - 2 6 1 - 2 6
®
The system automatically assigns the boot sequence of ATAPI
devices connected to the PCI IDE connector.
The ITE ® 8211F controller supports a maximum of two Ultra ATA
devices.
If you attach any IDE or ATAPI device to the PRI_PCIIDE1 connector,
prepare a driver disk with the ITE
the operating system.
We recommend that you connect the hard disk to the PRI_PCIIDE1
connector (black) and connect an optical drive to the PRI_IDE (blue)
connector for better performance and convenience.
PIN 1
PRI_PCIIDE1
NOTE: Orient the red markings
(usually zigzag) on the IDE
cable to PIN 1.
® 8211F controller before installing
C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n
C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n