Xerox C2424 - WorkCentre Color Solid Ink User Manual page 252

The power cord is attached to the system as a plug-in device on the side of the system. If it is
necessary to disconnect all electrical power from the system, disconnect the power cord from
the electrical outlet.
Warning
Do not remove the covers or guards that are fastened with screws unless you are installing
optional equipment and are specifically instructed to do so. Power should be OFF when
performing these installations. Disconnect the power cord when removing covers and
guards for installing optional equipment. Except for user-installable options, there are no
parts that you can maintain or service behind these covers.
The following are hazards to your safety:
■ The power cord is damaged or frayed.
Liquid is spilled into the system.
■
■ The system is exposed to water.
If any of these conditions occur:
1.
Turn off the system immediately.
2. Disconnect the power cord from the electrical outlet.
3.
Call an authorized service representative.
Maintenance Safety
■ Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your system.
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
■
performance and could create a hazardous condition.
■ Do not burn any consumables or routine maintenance items. For information on Xerox
supplies recycling programs, go to www.xerox.com/gwa.
Operational Safety
Your system and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your system.
System Supplies
■ Use the supplies specifically designed for your system. The use of unsuitable materials
may cause poor performance and a possible safety hazard.
WorkCentre® C2424 Copier-Printer
A-2