What to do if...
Remedying minor malfunctions yourself
If the programme progress display shows one of the following error
messages during operation:
–
(END) flashes 1x (problem with water inflow),
–
(END) flashes 2x (problem with water outflow),
–
(END) flashes 4x (door open),
please refer to the following table.
After the error has been remedied, press the
ton.
For other error messages (one or more flashing indicators in the pro-
gramme progress display):
Switch the appliance off and then on again. Reset the programme.
Press the
If the error is displayed again, please contact customer service.
Problem
Washing machine is not
working.
The door cannot be
closed.
The
(END) indicator
flashes 4x.
The
(END) indicator
flashes 1x.
(Problems with water
inflow)
The washing machine
vibrates when operating
or is not stable.
(START/PAUSE) button.
Possible cause
Mains plug not plugged in
or fuse not working.
Door not closed properly.
The
(START/PAUSE)
button was not pressed for
long enough.
Child safety device has been
activated.
The door is not closed prop-
erly.
Tap turned off.
The filter in the screw con-
nection on the inlet hose is
blocked.
Water tap is furred with
lime scale or is faulty.
The transportation lock has
not been removed.
The screw feet are not cor-
rectly adjusted.
(START/PAUSE) but-
Remedy
Connect the plug to a mains
socket. Check fuse.
Close door until the catch
audibly latches.
Press the
(START/
PAUSE) button for longer.
Deactivate the child safety
device.
Close the door properly. Re-
start the programme.
Turn on the tap.
Turn off the tap. Unscrew the
hose, remove the filter and
clean it.
Check the tap and have it re-
paired if necessary.
Remove the transportation
lock.
Adjust the feet as described
in the installation and con-
nection instructions.
19