Packet Data Access Points - Nokia N97 User Manual

group, tap the relevant access point if it is not already
highlighted, and select
to other dest..
To change the priority of an access point within the
group, select Options
priority.

Packet data access points

Select Menu Settings
>
Destinations Access
>
instructions on the screen.
To edit a packet data access point, open one of the
access point groups, and select an access point marked
with .
Follow the instructions from your service provider.
Select from the following:
Access point name
●
name from your service provider.
User name — The user name may be needed to
●
make a data connection, and is usually provided by
your service provider.
Prompt password
●
password every time you log in to a server, or if you
do not want to save your password in the device,
select Yes.
Password — A password may be needed to make
●
74
a data connection and is usually provided by your
service provider.
Options Organize
> >
Organize Change
> >
and Connectivity
>
point, and follow the
— You obtain the access point
— If you must enter the
Authentication
●
Copy your password encrypted or
password encrypted when possible.
Homepage — Depending on the access point you
●
are setting up, enter the web address or the address
of the multimedia message center.
Use access point
●
you want the device to ask for confirmation before
the connection using this access point is created, or
Automatically
the destination using this access point
automatically.
Select Options
following:
Network type
●
to transfer data to and from your device. The other
settings depend on the selected network type.
Phone IP address
●
address of your device.
DNS addresses
●
primary and secondary DNS servers, if required by
your service provider. To obtain these addresses,
contact your internet service provider.
Proxy server address
●
proxy server.
Proxy port number
●
the proxy server.
— Select Secure to always send
Normal to send your
— Select After confirmation
if you want the device to connect to
Advanced settings and from the
>
— Select the internet protocol type
(for IPv4 only) — Enter the IP
— Enter the IP addresses of the
— Enter the address of the
— Enter the port number of
if