Kyocera C8100DN - Color Laser Printer Operation Manual page 44

COMMAND CENTER Pages
Advanced > Protocols > NetBEUI
Advanced > E-mail > SMTP > General
40
To set up the Ethernet interface to communicate via AppleTalk, enables AppleTalk
protocol operation on the printing system.
Item
AppleTalk
Printer Name
Zone Name
Peer-to-peer printing is available using NetBEUI protocol. With this method, the printing
system is located in Windows Network Neighborhood.
Item
NetBEUI
Protocol
Printer Name
Workgroup
Comment
This machine can send Low Toner and other information via E-mail to the specified mail
address. To use the mail function, configure SMTP (Simple Mail Transfer Protocol) to
connect this machine to an E-mail server.
Item
SMTP Protocol
SMTP Port
Number
SMTP Server
Name
SMTP Server
Timeout
Description
Enables or disables AppleTalk protocol.
Specifies the name of the printing system in the AppleTalk
network.
Specifies the name of the AppleTalk zone (network). An
asterisk (*) means the default zone.
Description
Enables or disables NetBEUI protocol.
If NetBEUI is turned On, name resolution via NetBIOS
(NMB) can be used.
Printer Name correlates with Host Name in the TCP/IP
General page (refer to Advanced > Protocols > TCP/IP >
General on page 35). If you want to change the NetBEUI
printer name, change the TCP/IP Host Name.
Workgroup represents the workgroup which will appear in
Entire Network in Windows Network Neighborhood.
You can enter comments here. (This can also be left blank.)
Description
Enables or disables SMTP protocol. To use E-mail, this
protocol must be enabled.
Set the SMTP Port Number or use the SMTP default port 25.
Enter the SMTP server name or its IP address. If entering the
name, rather than the IP address, a DNS server address
must also be configured. The DNS server address may be
entered on the TCP/IP General page (refer to Advanced >
Protocols > TCP/IP > General on page 35).
Sets the timeout in seconds during which this machine tries
to connect to the SMTP server.
KYOCERA COMMAND CENTER