Kyocera C8100DN - Color Laser Printer Operation Manual page 42

COMMAND CENTER Pages
Advanced > Protocols > Netware
38
Each logical printer can be used with either the FTP, LPR, IPP, NetBEUI, or Raw Port
protocol. All printout to a non-existent port will be accomplished to Logical Printer1.
Item
TCP/IP Port
Number
Bi-directional
Printing
Start of Job
String
End of Job
String
This printing system supports both NDS and bindery printing in either print server mode
or remote printer mode.
NetWare setup requires installation of the following client software and logon with
Administrator Privileges. If you are unsure, please contact your network administrator.
With Novell Client, creation of the NetWare print objects with the AdminManager
NetWare Setup Wizard requires the NetWare Client from Novell. For NetWare printing,
you may use the NetWare Client from either Novell or Microsoft.
For Admin Privileges, network operations (creating queues etc.) require 'admin' or
'supervisor' privileges (or equivalent). Certain portions of AdminManager may be
inoperable if you attempt those operations without sufficient privileges.
Item
NetWare
Protocol
Bindery Mode
Frame Type
File Server
(Primary)
NDS Tree
Description
Specifies the port number for the logical printer as well as
the TCP raw port number (9100, etc.). Conversion is applied
to data that is input to the specified raw port in accordance
with the selected logical printer. This port is invalid if it is
given a port number that is the same as that of an already
specified port (e.g. FTP or LPD).
On or Off Bi-directional Printing using the TCP/IP raw port.
With this setting Off, all send data are discarded.
In order to have the data that is received from the printer
returned to the client when printing with PostScript, PJL and
other such commands, it is necessary to On bi-directional
printing.
Specifies the character string sent to the printer before
output directly to the output port (lp port). Specifies the
character string if it is necessary to transmit the control code
before printing.
Specifies the character string sent to the printer after directly
outputting to the output port (lp port). Specify a character
string, if it is necessary, to send a control code after printing.
Description
Enables or disables the Network Protocol.
Enables or disables Bindery Mode.
Sets the Frame type. You can choose from Auto, 802.3,
Ethernet-II, SNAP or 802.2.
Enter the name of the primary File Server.
Enter the name of the NDS Tree.
KYOCERA COMMAND CENTER