Dell 2330d - Laser Printer B/W Service Manual page 37

Error
200.28 First writing line of a page at the developer nip, but
laser servo cleanup is not complete. Likely pre staged
media or a fast paper feed.
200.29 Printhead drive control out of range due to an external
event beyond what the control is designed to handle.
Probable causes: ESD or noise on hsync signal.
200.30 Narrow media sensor covered during warm-up.
200.32 Media more than 14 inches too long over the manual
feeder sensor. Possible causes include multi-sheet
feed or pre-staged media in the tray.
200.33 Page from tray 1 did not reach the input sensor after
multiple attempts. Page did make it out of the tray at
least as far as the manual feeder sensor. Possible
cause is that the page stalled at the alignment gate.
200.34 Timed out waiting for page from tray 1 to reach the
input sensor after multiple pick attempts, but the page
was later detected at the input sensor while waiting for
any page(s) ahead to clear the paper path. Possible
cause is that the page is delayed at the alignment
gate.
200.35 Failed to create hsync during auto alignment
200.36 Lost hsyncs during auto alignment
200.37 Timeout on data collection during auto alignment
200.38 Interpage servo gap is smaller than expected for
printhead offset target evaluation
200.42 Rogue sheet is at the manual feed sensor while
flushing the paper path prior to declaring MPF source
empty.
200.43 The media is at the input sensor before interruption
occurs. Possible causes include bouncy sensor or an
exceptionally small gap, perhaps due to the media
being pre-staged in the source tray.
201.00 Paper jam between input and exit sensor
201.01 Transport motor identification failed to identify either
motor after two tries.
201.02 Exit sensor never made by leading edge of page. Also
known as internal jam.
201.03 Video never started on the page at the input sensor
within two inches after hitting the input sensor
201.05 Restart attempted after an internal jam without the
cover open/close event. It is likely that the jam was
never cleared.
Description Action
Verify that the media is approved. Inspect the wear
strips in the tray, and replace if they are worn.
Check the cable routing for the printhead. See
"Printhead service check" on page
Check that the narrow media flag rotates freely and
securely. If it is dislodged or broken, then repalce the
rear exit guide. See "Rear exit guide assembly
with sensor and reversing solenoid removal" on
page 4-48.
Verify that the media is approved. Inspect the wear
strips in the tray, and replace if they are worn.
Verify that the pick tires are clean, not worn, or filled
with paper dust. Replace the pick tires if necessary.
See "ACM pick tire roller removal" on page
The alignment roller may be binding. Call the next
level of support.
Check the printhead. See
check" on page 2-37.
Retry alignment.
Remove the media, realign the stock, and re-insert.
Do not let the top sheets to go beyond the wear
strips.
Remove the toner cartridge/PC kit and check for
obstructions between the input sensor and the fuser.
if the media continues to stop at the entrance or in
the fuser, then replace the fuser. See
removal" on page 4-20.
Check the main motor. See
check" on page 2-26.
Remove the PC kit and paper or debris at the input
sensor.
Check the printhead. See
check" on page 2-37.
Check the paper path and remove any media in the
path.
Diagnostics information
2-37.
4-3.
"Printhead service
"Fuser
"Main motor service
"Printhead service
2-11