Open The Display - Panasonic CF-27LBAGHEM - Toughbook 27 - PIII 500 MHz Operating Instructions Manual

6
Latches
Cover
3
2
1
3
2
Power Switch
Latch
Power Switch
6 Slide the latches outward.
4
Connect your computer to a power outlet
CAUTION
Be sure the AC adapter is connected until completing Step 9 on page 13.
Handling the AC adapter
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adapter with your computer. Using an AC adapter
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
When closing the cover
First insert the top of the cover, then close the cover.
5

Open the display

Pull the carrying handle forward.
1
Lift up the latch.
2
Lift open the display.
1
3
6
Read the LIMITED USE LICENSE AGREEMENT
Before removing the seal covering the power switch, read the LIMITED USE LICENSE
AGREEMENT. Removal of this seal indicates agreement to the terms specified. After
you have agreed to the terms, you may turn your computer on.
7
Turn your computer on
Slide the power switch toward the rear of the computer and hold it for approximately
one second until the power indicator (
CAUTION
After confirming that the power indicator has turned on, do not touch the power
switch until Windows setup has started.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
(
) turns on before releasing it.
page 27)
9