Advertisement
To insert the colored buttons, do the
following:
1. Holding the transmitter with the buttons
face down, remove the case back by using
the blade of a small screwdriver to pry it
open (see Figure 2).
2. Carefully remove the PC board by its
rubber casing, making sure the board does
not come out of the casing. Do not bend
the exposed battery tabs on the PC board.
3. Replace the desired buttons, either red or
blue, in each button's designated opening
(see Figure 3).
4. When finished, replace the PC board,
making sure the button tabs on the board
face the four buttons, and snap the case
front and back together.
After inserting the new buttons, we recommend
you check the 5804E for proper operation.
Figure 2: Battery tabs shown
Figure 3: 5804E shown open, buttons
facing down
FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE
ALARM SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL
WITH WHICH THIS DEVICE IS USED.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
FCC ID: CFS8DL5804E
ÊN7674-6V2LŠ
N7674-6V2 10/04 Rev. A
REPLACING THE BATTERIES
1. Remove case back by using the blade of a
2. Remove old batteries.
3. Place batteries in case back locations (see
4. To close, snap case front and back
Important Note: Do not remove Printed
Circuit Board.
SPECIFICATIONS
Blue
Unit Dimensions:
2.25" W x 1.50"H x 0.5" D
57mm W x 38mm H x 12.7mm D
Red
Battery:
Maxell CR2025, Duracell DL 2025, or Varta
CR2025
FCC NOTICE
CANADA: 573F-5804E
+ POS. end
must face down
+ POS. end
must face down
small screwdriver to pry it open.
diagram above). + POS END MUST FACE
DOWN.
together.
Hide quick links:
Advertisement
