Program Cards And Pins - Chamberlain KPR2000 Manual

PROGRAMMING
5

Program Cards and PINS.

Programming will vary depending on the access configuration. Follow the instructions according to your access configuration.
GENERAL PROGRAMMING INFORMATION
• User ID Number: Assign a user ID number to the access code in order to keep track of the users of access cards or PINs. The user ID
number can be any number from 1~2000. IMPORTANT: User IDs do not have to be proceeded with any leading zeros. Recording of User ID
is critical. Modifications to user data require either the card or the User ID be available.
• Proximity Card: Any 125 KHz industry standard 26 bit Wiegand Proximity Card.
• Keypad PIN: The PIN can be any 4~8 digits between 0000~99999999 (except 1234 which is reserved for factory testing). IMPORTANT: PINs
less than 1000 must be preceded with leading zeros. PINs greater than 9999 do not require any leading zeros.
ADD USER CARD(S)
Programming Step
1. Enter Program Mode
2. Add Card: Using Auto ID
(Allows KPR2000 to assign
Card to next available User ID
number)
OR
2. Add Card: Select Specific ID
(Allows manager to define a
specific User ID to associate
the card to)
OR
2. Add Card: Block Learn
(Allows manager to add up to
2000 cards to the KPR2000
in a single step.†) Takes 2
minutes to program.
3. Exit Program Mode
DELETE USER CARD(S)
Programming Step
1. Enter Program Mode
2. Delete Card - By User ID
OR
2. Delete Card - By Card
OR
2. Delete Card -By Card
Number
3. Exit Program Mode
† Format for programming specific Card Numbers: Facility Code + ID
Number (including leading 0's) Example: FAC- 24, ID- 100 would be
entered as:
26 Bit: 02400100
30 Bit: 002400100
34 Bit: 0002400100
ACCESS CONFIGURATION: CARD OR PIN & CARD ONLY
Keystroke Combination
✱ (Master Code) #
1 (Read Card) #
Repeat Step 2 for additional user
cards
1 (User ID) # (Read Card) #
5 (User ID) # (The first card
number) # (Card Quantity) #
Card quantity = number of cards to
be enrolled
✱
Keystroke Combination
✱ (Master Code) #
2 (User ID) #
Deleting by User ID number will clear
cards and PINs
2 (Read Card) #
Requires the user card. Deletes ONLY
the card number
2 (Card Number) #
Deletes ONLY the card number †
✱
ADD OR DELETE A PIN
Programming Step
1. Enter Program Mode
2. Add a PIN
Assigns PIN to user ID
number
OR
2. Delete a PIN
Deletes the User ID number
and associated PIN
3. Exit Program Mode
CHANGE A PIN
This operation is executed from outside of Program Mode.
Programming Step
1. Change a PIN
6
Keystroke Combination
✱ (Master Code) #
1 (User ID) # (PIN) #
Repeat Step 2 for additional PINs
2 (User ID) #
Repeat Step 2 for additional PINs
✱
Keystroke Combination
✱ (User ID) (Old PIN #) (New PIN #)
(New PIN #)